NStor Technologies Disk Array Enclosure Uživatelský manuál Strana 40

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 92
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 39
Installation
Fast Wide SCSI Mode
28
Two Dual-Bus Enclosures
With this configuration you will have a total storage capacity of up to 290 GB
(using 18 GB disk drives) which provides 145 GB per channel per subsystem
enclosure.
This configuration is similar to the “Single Dual-Bus Enclosure” except that the
capacity is expanded with a second cabinet providing a total of eight drives per
SCSI channel.
CAUTION: Ensure that the power switch is in the OFF (O) position for both the
host system and the CR8e subsystem before connecting any cables.
1 Connect one end of a one meter data cable to the Channel #1 connector on
the AM RAID Controller.
2 Connect the other end of the first data cable to the Channel #0 SCSI connector on
the right side or upper I/O Interface card.
3 Connect one end of the second one meter data cable to the Channel #2 connector
on the AM RAID Controller.
4 Connect the other end of the second data cable to the Channel #1 SCSI connector
on the right side or upper I/O Interface card.
5 Locate the jumper cables. Connect one end of a jumper cable to the Channel #0
SCSI connector on the left side or lower I/O Interface card in the first cabinet.
Rear View CR8e
with Dual-Bus Module installed.
TOP
I/O Interface
Card
1 meter data cable
14-inch jumper cable
14-inch jumper cable
1 meter data cable
I/O Interface
Card
Ultra SCSI
RAID Controller
Ch 0
Ch 1
Ch 0
Ch 1
Ch 1
Ch 2
Rear View CR8e
with Dual-Bus Module installed.
TOP
I/O Interface
Card
I/O Interface
Card
Ch 0
Ch 1
Ch 0
Ch 1
Zobrazit stránku 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 91 92

Komentáře k této Příručce

Žádné komentáře